RED DSMC V5.2 Especificaciones descargar pdf (Pagina 165)

164 164

HEADPHONE

A 3.5mm stereo jack provides two channels of adjustable level analog audio for monitor headphones.

Headphone Output Connector

PIN SIGNAL DESCRIPTION DIRECTION

A (TIP) LEFT Left channel audio Out

B (RING) RIGHT Right channel audio Out

C (SLEEVE) GND Camera ground --

The camera’s four audio channels may be monitored in pairs: either 1L - 2R or 3L - 4 R or as a quad mix

of 1+3L – 2+4R based on the MIX parameter. Default is 1L-2R.

Output volume may be adjusted as follows.

Volume: (master volume) Adjusts headphone volume equally for left and right outputs.

Range is -18dB to 0dB in 1dB steps. Default is -9dB.

NOTE: for maximum output signal quality, only use high impedance headphones.

NOTE: in Version 3.x software the above selection is not available, the output is set to 1L / 2R.

SYNC (VIDEO SYNC)

A 4-pin LEMO connector supports shutter synchronization, GPI, timecode and genlock input signals.

The shutter Sync input signal acts as an immediate response hardware trigger to commence a scan.

This is useful for motion control and other applications where the camera is driven by a master timing

device. When using SYNC as the camera shutter timing reference, fine shutter start time timing

(SHUTTER PHASE) is disabled; make any desired timing adjustments at the external SYNC generator.

Alternatively, this input may be used as a GPI (General Purpose Input) trigger, whose function is

programmed in the USER KEYS menu. Default function for the GPI trigger is Record Start / Stop.

The SMPTE timecode input provides a frame accurate time stamp for each frame of recorded video.

External TC must be chosen in the Project > Timecode menu. When SMPTE timecode is detected it will

align the internal TC value to the external TC signal at every :00 frame crossing of the external TC signal.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 239 240

Sin comentarios

RED DSMC V5.2 Especificaciones Pagina 165