RED DSMC V5.2 Especificaciones descargar pdf (Pagina 127)

126 126

GROUP

A camera can also be identified as a member of a GROUP of devices. (For example, a group "3DRIG_A"

could include two cameras "CAM_A_L" and "CAM_A_R"). The default group is named "DEFAULT".

Group names (like camera Names) can be used to uniquely address commands to a specific group of

networked cameras. Note: the group name is limited to 8 characters, default name is DEFAULT.

TARGET

Using TARGET the user can specify if this camera can send commands to ALL devices on the network,

to NONE of the devices on the network (meaning the camera will only listen to messages and not

originate messages) or to a specific TARGET device - which can either be the NAME of a specific

camera or device or a name of a GROUP of cameras or devices.

This structure allows for a lot of flexibility. For example on a multi-rig 3D shoot the user can either send

commands to an individual camera (e.g. Set CAM_A_L to 1/48th exposure), to a group of cameras (e.g.

Set "3DRIG_A" to 48 FPS), or to all cameras (e.g. Start Recording on all cameras). It is important to note

that with the exception of the NONE setting, all command filtering is happening on the receiver side of

the communication link.

SERIAL PROTOCOL

The camera can communicate to external devices via RS232 Serial Port and / or the Gigabit Ethernet

Port.

This selection allows the user to specify the serial communications PROTOCOL. Available options are

NONE, ELEMENT TECHNICA, 3ALITY SPC 7100 and 3ALITY SPC 7000. Default is NONE.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 239 240

Sin comentarios

RED DSMC V5.2 Especificaciones Pagina 127