Red DSMC FAN 2.0 UPGRADE Manual de usuario descargar pdf (Pagina 13)

DSMC FAN 2.0 UPGRADE INSTRUCTIONS

955-0012, REV-D | 13

6. Use a T10 Torx driver to install the two (2) M3x0.5 x 6 mm cap screws (included) that attach the fan grill to

the DSMC BRAIN. DO NOT FULLY TIGHTEN.

7. Tighten the M3x0.5 x 6 mm screws evenly. DO NOT exceed 70 in-oz, or damage may occur.

WARNING: DO NOT OVERTIGHTEN.

8. Reattach the lens mount, lens, and any DSMC accessories that you removed from the BRAIN.

9. Upgrade your firmware or perform a hardware rediscover to ensure that your camera recognizes the new

fan. For more information, go to “Configure Firmware” on page 26.

NOTE: If you need to replace any screws, please contact your Bomb Squad representative.

Install Cap Screws

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sin comentarios

Red DSMC FAN 2.0 UPGRADE Manual de usuario Pagina 13