RED DSMC V5.2 Especificaciones descargar pdf (Pagina 35)

RED DSMC OPERATION GUIDE

INSTALL THE MODULE ADAPTOR

You must install an adaptor module on the back of the BRAIN before you install a DSMC module.

REQUIRED TOOL: T20 Torx

driver

1. Turn off the BRAIN.

2. Remove the REDMOTE, if attached.

3. Position the Module Adaptor over the V-mount on the rear of the BRAIN.

4. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2)

turns each using a T20 Torx driver. DO NOT FULLY TIGHTEN.

5. Fully tighten the four (4) screws in a cross pattern (“X” pattern). DO NOT OVERTIGHTEN.

Install Module Adaptor

Install Screws

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 196 197

Sin comentarios

RED DSMC V5.2 Especificaciones Pagina 35